What should you check first when a commercial fridge stops cooling?
These checks take a few minutes and need no tools. Work through them in order, and keep the door shut between checks so the cabinet does not lose more cold air.
| Check | What to look for | What you can do |
|---|---|---|
| Power | A blank display, no fan noise, a tripped switch | Check the plug, the switch and the fuse or circuit breaker. Williams’ troubleshooting guidance puts the power supply first when a cabinet is not working. If the breaker trips again, leave it off and call an engineer. |
| Temperature setting | A set point that has been changed or knocked | Put it back to your normal setting. Government guidance is to set fridges to 5°C or below. |
| Doors and seals | A door left ajar, a door alarm, a split or loose seal, frost around the door | Close the door fully and clear anything stopping it shutting. A torn or loose seal lets warm air in and needs replacing. |
| Loading | Shelves packed tight, stock pushed against the back or the fan cover | Take some stock out and leave space for air to move. Williams warns that overfilling a cabinet disrupts the air circulation inside it. |
| Air around the cabinet | Boxes, cloths or other equipment against the grilles, a cabinet boxed in next to hot equipment | Clear the grilles so air can reach the condenser. Refrigeration has to work harder as the room gets hotter. |
| Condenser | Grey dust or greasy fluff on the condenser coil or its grille | Switch off and unplug first. If your manual shows how, brush or vacuum the dust off the outside of the coil. A greasy coil needs a service. |
What should you not do?
- Do not chip or scrape ice off the evaporator. The evaporator is the cold coil inside the cabinet and it carries the refrigerant, so a pierced coil becomes a refrigerant leak.
- Do not open the refrigeration circuit or add refrigerant. In Great Britain anyone who works on refrigeration containing F gas must hold an F-gas qualification, and releasing F gas into the air on purpose is against the law.
- Do not remove panels that need tools or touch the wiring. Williams lists a failed fan motor, a faulty compressor relay and a loose electrical connection as jobs for an engineer.
- Do not keep clearing a temperature alarm and carry on. An alarm that keeps coming back is telling you the cabinet cannot hold its temperature.
What do ice, water and alarms tell you?
Some signs point to a fault that cannot be fixed from the outside of the cabinet:
- Ice building up on the evaporator. When the defrost fails, ice blocks the coil and cold air can no longer circulate. If your manual describes a manual defrost, you can empty the cabinet into a working fridge and follow it, but ice that returns within days means the defrost system needs an engineer.
- Water inside or under the cabinet. This is often a blocked defrost drain.
- The compressor running all the time while the cabinet stays warm. This points to a clogged condenser, a failed fan or a refrigerant fault.
- An error code or temperature alarm. Codes vary by make. On Williams cabinets, for example, E1 and E2 mean a control probe failure, and the guidance for those and for a high or low temperature alarm is to call an engineer.
- Unusual noise from the fans or the compressor.
How do you keep food safe while the fridge is down?
In England, chilled food must by law be kept at 8°C or below, and government guidance is to set fridges to 5°C or below. Chilled food can be kept above 8°C for one period of up to 4 hours. After that it must be thrown away. Food that has been above 8°C for less than 4 hours can go back into a working fridge and be kept cold until it is used.
- Check the temperature of the food with a probe thermometer, not just the cabinet display.
- Move the food that most needs chilling first. GOV.UK lists food with a use-by date, cooked dishes and ready-to-eat food such as prepared salads and desserts.
- Keep the faulty cabinet’s door shut once it is empty, so the engineer can see how it behaves.
- Write down the times, the temperatures and what you moved or threw away, in your food safety records.